Not only does it spread the cost, but it can also increase the amount and variety of the preserved food you store away. Additionally, a group purchase can also lead to purchasing bulk quantities of food to freeze dry.

I've also added an oil catch can that does a wonderful job of trapping oil vapor exiting the exhaust of the pump. Now instead of coating the area in a fine oil mist, the oil settles into the can. The clear tube on the side of the can lets you know how full the can is.

By not allowing yourself functioning amenities as basic as a fridge or freezer, you’re making life difficult in a number of unnecessary ways. Doubtless, by attending to your basic appliance problems as soon as they arise, there’s so much to gain.

Do you have any vacuum gauges at all to test the pump? ( Though I doubt that is the problem based upon your tests )

(had to replace the whole galvanized T piece with new wires in it) Seems they are epoxied in there, and in my experience passthroughs are a problem spot, so it's not at all surprizing that there was a slight leak there. In any case, I thanks the folks at HR for sending parts and sticking with me throughout.

Agree entirely on the fittings! After many emails and phone calls to HR, some advice that didn't pan out, and some parts replacement, the unit is back in business! Turns out it was the wire passthrough for the heater wires.

Remove all ice every oito hours of drying time. It is amazing how much faster the drying time drops doing this. A side benefit is water vapor does not contaminate the oil as fast. I've gotten up to 20 cycle per oil change by carefully monitoring the oil and water.

The item is then heated up again and as the water starts to leave instead of melting (ie going from a solid to a liquid) it sublimates (ie goes from a solid to a gas) under the influence of the negative pressure produced by the vacuum. So you are left with the cell minus water in an intact shape and size.

14 Posted December 16, 2015 (edited) On 7/31/2015 at 11:12 PM, TonyC said: Somehow this post got posted twice so I'll edit the second one with some more useful information. I remember reading somewhere in this thread where somebody was asking how long you run the freeze cycle with pre-frozen food. I have my chest freezer set to -12F, and I usually let the freeze dryer cool for an hour before I put the frozen food in. After I load the food in I wait another half hour to start the drying process. I've had a lot of cycles that the total time between pulling one batch out and starting the drying cycle on the next is around 2 hours. I'm running mine in a cold garage, so it cools down pretty quickly. If you have yours in a warm room it would probably take a little longer.

You can decide between electric or gas fryers. Electric fryers take a longer to heat up, but they recover quicker between frying cycles. They are also easier to maintain. Gas fryers are able to go to higher temperatures, and they also heat up faster than electric.

Moisture and temperature are the two critical factors in optimal food storage. Moisture - the humidity in the storage environment should be low. If dried foods pick up moisture from the storage area, molds Buy Now and bacteria can grow. This can lead to spoilage

We use cookies to enhance your browsing experience and analyze our traffic. By continuing to use our sitio, you agree to our use of cookies as described in our privacy policy.. If you wish to opt-out of cookie usage, you can do so by clicking “Opt-Out".

In many cases, people are in need of a fridge repaired but are too afraid of the potential cost of having to buy a new one; as a result, they avoid cooking for days at a time and dabble in the bad habit of ordering take incessantly.

Forgive me for the extremely long post but I thought other southerners may also face this problem and could use this information.